This USB Joystick Controller allows you to breakout the pins of a Arduino Pro Micro and expand the number of possible button with shift registers.

**PICTURE SHOWN FOR REFERENCE ONLY, You receive an Unsoldered PCB with Header Pins**

The unit is 80mm  x 65mm and has the following
Breakout of all 9 Analog inputs to 3 pin headers providing a GND and VCC Pin
using 5 shift registers provides 40 Digital inputs
Breakout reamining 6 Pins to 3 pin Headers with a GND and VCC Pin
Onboard Green LED’s powered by A10 Pin (PWM) enabled by a solder jumper
Header pin for LED Rail to expand with own lighting.

The board also has CLK Latch and Data outputs so you could daisy chain another Board (for digital inputs only) if you required.

With this USB Joystick Controller board you can provide your own Pro Micro and code, I can offer limited support at this stage.

In the future I will offer a Pro micro which I will load with a basic sketch with a joystick with Buttons an Axis with a simple GUI that will allow you to customise the behaviour of all the pins further, but that will be released at an undetermined time.